| Spars fastened to board | |
| Ribs glued in | |
| Center panel is made from one piece, then cut into two pieces | |
| Stop for wing steel | |
| Balsa end piece in tip | |
| Wingtips is also made from one piece | |
| End piece shaped | |
| Different angle | |
| Wingtip ready to be glued to center panel | |
| Wingtip glued to center panel | |
| Closeup one stabilizer | |
| Stab ready to be covered with tissue | |
| Balsa pieced glued in place | |
| Cyano glue used in this picture | |
| Halfway there | |
| Without covering | |
| Frontend colored (note this timer not availible) | |
| Towline arrangement | |
| Rudder as seen from space | |
| Rudder | |
| More rudder | |
| Balsaloc is used to attatch the Polyester tissue | |
| Polyester tissue heated on to the wing | |
Bygg & Modell Lars Larsson
Sågvägen 1
466 94 SOLLEBRUNN
Sweden
Tfn 0046 322-421 17
Mobil: 0046 709 400482
E-post: ffservice@tele2.se